The Forestry Forum is sponsored in part by:

Forestry Forum
Sponsored by:

TimberKing Sawmills

Toll Free 1-800-582-0470

LogRite Tools

Forest Products Industry Insurance

Norwood Industries Inc.

Sawmill & Woodlot Magazine

Your source for Portable Sawmills, Edgers, Resaws, Sharpeners, Setters, Bandsaw Blades and Sawmill Parts

EZ Boardwalk Sawmills. More Saw For Less Money! sponsored by Northeast STIHL

Woodland Sawmills

Peterson Swingmills

 KASCO SharpTech WoodMaxx Blades


Sawmill Exchange

BRUTE FORCE Authorized Dealer

Woodshax Outdoor Vending Solutions


Council Tool

Baker Products



Author Topic: my new 'girl' (a TJ200)  (Read 4643 times)

0 Members and 1 Guest are viewing this topic.

Offline bushmechanic

  • Senior Member
  • ****
  • Posts: 801
  • Age: 47
  • Location: Milton,Newfoundland,Canada
  • Gender: Male
  • Someone else has it worse than you.
    • Share Post
Re: my new 'girl' (a TJ200)
« Reply #40 on: July 17, 2017, 07:30:36 PM »
You seem to be on top of this! I always thought it was cut down to 6 volts while running. I know some systems use 12 volts for starting then through the resistor for running. Trouble is if you put it direct voltage then it will go to what the alternator puts out, say 14 volts.

Offline krusty

  • Full Member x2
  • ***
  • Posts: 151
  • Location: Canuckistan
  • I'm new!
    • Share Post
Re: my new 'girl' (a TJ200)
« Reply #41 on: July 18, 2017, 12:05:47 AM »

I thought I read somewhere else that the ideal voltage for a UC12 coil was around 8v. As for the 12v start, you will see starter solenoids with an in and out for high current and then 1 or 2 terminals in the 1/8" range. If it has one, it is to activate the solenoid. If it has 2, 1 is to activate the solenoid, the other is to connect to the + terminal on the ignition coil thus bypassing the resistor and is only activated when the starter is cranking.

There is an alternator on my old TJ but wiring that up is on my todo list :) Since it left my house back in the winter is has been in the woods with only fluid top ups and an ignition coil.  I will bring it back home in the fall for a once over before the cold comes.

Share via delicious Share via digg Share via facebook Share via linkedin Share via pinterest Share via reddit Share via stumble Share via tumblr Share via twitter

that's my girl!

Started by grouch on General Board

10 Replies
Last post June 16, 2016, 11:24:18 PM
by sandhills
the girl can cut

Started by woodmills1 on Sawmills and Milling

59 Replies
Last post August 13, 2009, 08:42:53 PM
by backwoods sawyer
My Birthday Girl

Started by Magicman on General Board

21 Replies
Last post September 11, 2012, 11:30:46 PM
by Okrafarmer
NZ girl making it big.

Started by Ianab on General Board

11 Replies
Last post December 29, 2013, 11:40:39 PM
by beenthere

Powered by EzPortal