The Forestry Forum is sponsored in part by:


Forestry Forum
Sponsored by:


TimberKing Sawmills



Toll Free 1-800-582-0470

LogRite Tools



Norwood Industries Inc.


Sawmill & Woodlot Magazine



Your source for Portable Sawmills, Edgers, Resaws, Sharpeners, Setters, Bandsaw Blades and Sawmill Parts

EZ Boardwalk Sawmills. More Saw For Less Money!

STIHLDealers.com sponsored by Northeast STIHL


Woodland Sawmills

Peterson Swingmills

 KASCO SharpTech WoodMaxx Blades

Turbosawmill

Sawmill Exchange

BRUTE FORCE Authorized Dealer

Woodshax Outdoor Vending Solutions

FARMA


Council Tool

Baker Products

ECHO-Bearcat

Arborwear



Author Topic: 2nd floor  (Read 452 times)

0 Members and 1 Guest are viewing this topic.

Offline Klunker

  • Full Member
  • **
  • Posts: 82
  • Location: SE Wisconsin
  • Gender: Male
  • I'm new!
    • Share Post
2nd floor
« on: December 07, 2017, 12:32:08 AM »


here is a view of the 2nd floor.
benches are heated on both floors.

Offline Klunker

  • Full Member
  • **
  • Posts: 82
  • Location: SE Wisconsin
  • Gender: Male
  • I'm new!
    • Share Post
Re: 2nd floor
« Reply #1 on: December 07, 2017, 12:35:44 AM »
mods, can you move this post to "new heater" post in same

Offline samandothers

  • Senior Member x2
  • *****
  • Posts: 2140
  • Location: Charlotte NC To SW Va.
  • Gender: Male
  • Been learning on FF since 1/20/12
    • Share Post
Re: 2nd floor
« Reply #2 on: December 07, 2017, 10:32:38 AM »
Masonry Heater? 

Offline Klunker

  • Full Member
  • **
  • Posts: 82
  • Location: SE Wisconsin
  • Gender: Male
  • I'm new!
    • Share Post
Re: 2nd floor
« Reply #3 on: December 08, 2017, 01:35:09 PM »
Masonry Heater?

yes, 2nd floor of heater


Share via delicious Share via digg Share via facebook Share via linkedin Share via pinterest Share via reddit Share via stumble Share via tumblr Share via twitter

xx
Radiant Floor heating within a finished ceiling/ floor.

Started by Rooster on Timber Framing/Log construction

42 Replies
12001 Views
Last post May 16, 2011, 11:50:11 AM
by frwinks
xx
Cut out the floor-now what?

Started by Karl_N. on General Board

1 Replies
482 Views
Last post October 17, 2004, 05:41:57 PM
by CHARLIE
xx
ash floor

Started by trapper on Sawmills and Milling

3 Replies
1192 Views
Last post December 30, 2007, 10:41:40 AM
by Robert Long
xx
Floor installation

Started by metalspinner on Drying and Processing

2 Replies
1084 Views
Last post November 02, 2007, 11:18:05 PM
by MikeH
 


Powered by EzPortal