Recommendations for T&G cutters on 1/2" arbor

[Ljohnsaw]

I might not be searching with the right words so "search" didn't find me what I was looking for in old threads here.  I have an old Delta shaper with a ½" arbor.  It has a ½hp motor that I will upgrade to 1hp.  I want to do some T&G on some cedar boards.  Eventually, I will be doing some 1" stock, but right now about ½ to ¾".  I also want the little V at the joint.  I see lots of butt joint T&G cutters on Amazon, but not with the V.

Anyone have some recommendations?  I will be doing LOTS of boards for my cabin walls so I suppose carbide tipped will be the best.  With the amount that I'm doing (and "soft" cedar), I'd like to make the cuts in one pass if possible.

Thanks!

[PC-Urban-Sawyer]

You might want to try MLCS. They list a set as # 1088 on this page: http://www.mlcswoodworking.com/shopsite_sc/store/html/smarthtml/pages/shaper_join.html#tongue_and_groove_straight_anchor

You  might want to just use a router table setup. I used their smaller router bit set but you might want to use the larger one shown on this page: http://www.mlcswoodworking.com/shopsite_sc/store/html/smarthtml/pages/bit_tongue_groove.html#tong_v_notch_anchor

Good luck and be careful!

Herb

[Ljohnsaw]

Just ordered a set from MCLS.  We'll see how it goes - thanks.