iDRY Vacuum Kilns

Sponsors:

Eaton pto

Started by rdobb13, March 12, 2016, 10:57:51 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

rdobb13

I have a 230d with an Eaton pto.  I had case trouble a while back, fixed that but recently noticed there is a lever to disengage the winch.  I pulled the pto off and after pulling one pin out of the pinion gear  I was walking over to press out the bottom shaft and a spacer fell out.  I can't tell where the spacer came from....does anyone have a schematic of an Eaton pto? 

Thank You Sponsors!