iDRY Vacuum Kilns

Sponsors:

Edger Question

Started by smwwoody, July 10, 2003, 07:24:34 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

smwwoody

Does anyone know the proper speed to run a 12" insertrd tooth saw at? ??? ???
Full time Mill Manager
Cleereman head rig
Cooper Scragg
McDonugh gang saw
McDonugh edger
McDonugh resaw
TS end trim
Pendu slab recovery system
KJ4WXC

D._Frederick

Smwwoody,
The upper limit on surface feet minute for a insert tooth saw is about 6000ft/min., for your 12 inch diameter saw would be about 1900-2000 rev./ min.

smwwoody

Thanks D. that will help

Woody
Full time Mill Manager
Cleereman head rig
Cooper Scragg
McDonugh gang saw
McDonugh edger
McDonugh resaw
TS end trim
Pendu slab recovery system
KJ4WXC

Thank You Sponsors!