LT 40 Super Hydralic Fault Code

[New Mill]

I have a LT 40 HD Super and after sawing awhile today the mill lost all control function and has shown a fault code of TL module failure.  What is this?  The computer doesn't work for auto cuts needs replaced.  Factory said they would need to replace with newer modle.

Thanks for any ideas.

[Water Dogs]

Welcome New Mill to the forum. When we got our Lt 40 a few week back it ran like a champ for the demo. About 1hour later she started missing and went dead in the water. Loose wires from vibration wigged connectors and back on line. Later found a lead loose in fuse box not tight from factory? Not sure if this is the same on your Mill hope this helps.


                                      Water Dogs

[MartyParsons]

Hello,
   TL refers to Top Left. Mosfet module for Setworks. Low battery voltage, loose connections can cause this or replace the mosfet module. TL, BL sometimes does not refer to the exact location.
Marty

[LeeB]

Hello,
  TL refers to Top Left. Mosfet module for Setworks. Low battery voltage, loose connections can cause this or replace the mosfet module. TL, BL sometimes does not refer to the exact location.
Marty

@MartyParsons 
Are these mosfet modules still available? 

[MartyParsons]

Yes I have some in stock. They are used.

[petefrom bearswamp]

Good old boy Marty.

[LeeB]

I need three of them if you have that many.