The Forestry Forum is sponsored in part by:

Forestry Forum
Sponsored by:

TimberKing Sawmills

Toll Free 1-800-582-0470

LogRite Tools

Forest Products Industry Insurance

Norwood Industries Inc.

Sawmill & Woodlot Magazine

Your source for Portable Sawmills, Edgers, Resaws, Sharpeners, Setters, Bandsaw Blades and Sawmill Parts

EZ Boardwalk Sawmills. More Saw For Less Money! sponsored by Northeast STIHL

Woodland Sawmills

Peterson Swingmills

 KASCO SharpTech WoodMaxx Blades


Sawmill Exchange

BRUTE FORCE Authorized Dealer

Woodshax Outdoor Vending Solutions


Council Tool

Baker Products



Author Topic: Guide Roller Diameter  (Read 177 times)

0 Members and 1 Guest are viewing this topic.

Offline Piddler

  • member
  • *
  • Posts: 7
  • Location: Mohawk wv
  • Gender: Male
  • I'm new!
    • Share Post
Guide Roller Diameter
« on: February 08, 2018, 03:18:33 PM »
Could someone tell me the diameter of the Cooks standard guide rollers (front and back) for the 1-1/4 blade . They give a 2" diameter but for what end . Needing these measurements so I can make the base for them to bolt to. Thanks in advance.
When I ask the same question more than once please excuse me since I suffer from (CRS)

Offline ladylake

  • Senior Member x2
  • *****
  • Posts: 4701
  • Age: 65
  • Location: grey eagle mn
  • Gender: Male
  • I need to edit my profile!
    • Share Post
Re: Guide Roller Diameter
« Reply #1 on: February 08, 2018, 05:18:25 PM »

 Cooks sells 2    2 1/2  and  3" diameter roller guides with flanges on the back, my TK runs 3" guides which I like better as they don't turn as fast, don't wear out as fast and should be a little easier on the blade but they cost more.  The diameter they list is for the guide surface, the flange will be quite a bit bigger.  Steve
Timberking B20 12000 hours +  Case75xt grapple + forks+8" snow bucket + dirt bucket   770 Oliver   Lots(too many) of chainsaws, Like the Echo saws and the Stihl and Husky     W5  Case loader   1  trailers  Wright sharpener     Dino setter Volvo MCT125c skid loader

Share via delicious Share via digg Share via facebook Share via linkedin Share via pinterest Share via reddit Share via stumble Share via tumblr Share via twitter

Roller Guide Arm Issue

Started by pri0ritize on Sawmills and Milling

6 Replies
Last post June 25, 2013, 07:35:31 AM
by MartyParsons
roller guide upgrades

Started by True North on Sawmills and Milling

4 Replies
Last post February 25, 2013, 02:29:06 PM
by True North
WM Roller Guide - took a hit and broke off

Started by Andries on Sawmills and Milling

37 Replies
Last post February 08, 2015, 08:35:42 PM
by Andries
Roller guide setting

Started by bandmiller2 on Sawmills and Milling

18 Replies
Last post August 27, 2012, 10:57:15 AM
by 5quarter

Powered by EzPortal