iDRY Vacuum Kilns

Sponsors:

Just checking on posting pictures

Started by dnalley, June 17, 2008, 03:29:49 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages1
User actions

dnalley

June 17, 2008, 03:29:49 PM
Trying to see if I can post pictures w/o having to bother Furby again.  Hope this is the right place, and hope this works.  Thanks, Dwight

leweee

#1
June 17, 2008, 03:50:45 PM
Nice Buck.......and I like the watchmakers lathe. ;D
just another beaver with a chainsaw &  it's never so bad that it couldn't get worse.

LeeB

#2
June 17, 2008, 04:12:54 PM
What you turning on that lathe?
'98 LT40HDD/Lombardini, Case 580L, Cat D4C, JD 3032 tractor, JD 5410 tractor, Husky 346, 372 and 562XP's. Stihl MS180 and MS361, 1998 and 2006 3/4 Ton 5.9 Cummins 4x4's, 1989 Dodge D100 w/ 318, and a 1966 Chevy C60 w/ dump bed.

dnalley

#3
June 17, 2008, 04:38:16 PM
Most of the lathes I've run could probably be bolted to that face plate :D  , Been about three years since I took the picture, but near as I can remember it had about a 96or 98 foot bedwith an 8 or 10 foot face plate.  I couldn't believe the boring bar for this thing!  Friend of mine was running it at the time and I just had to go see it.  I guess there are bigger and better ones out there, but this country boy was "impressed".  Can't remember what the shaft was for.  Dwight
Print
Go Up Pages1
User actions

Thank You Sponsors!