iDRY Vacuum Kilns

Sponsors:

Frick husk.

Started by jdw, August 31, 2016, 06:07:03 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

jdw

Anyone ever built a husk out of steel? If so what size did you use, I beams or channel?

Ron Wenrich

Here is a husk assembly for a Frick, all steel:  http://www.fricksawmills.com/pdfs/00MANUALCOMPLETE.pdf  Go to Figure 2.  This is for a 0 or 00.  Seems like 01 is the same.

Might want to think about converting the feedworks over to hydraulic to eliminate all the belts and make an easier conversion, if you can afford it.
Never under estimate the power of stupid people in large groups.

Thank You Sponsors!