iDRY Vacuum Kilns

Sponsors:

Aftermarket saw parts

Started by ohiowoodchuck, December 27, 2015, 05:47:22 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

ohiowoodchuck

What's your guys take or experience with them. Which ones seem to fit the best. I got a 660 I'm wanting to rebuild, I will not take a chance on the bearings, seals, piston or cylinder but what's your take on stuff like oil pumps, clutches and handles.
Education is the best defense against the media.

ZeroJunk

I think if I was going OEM with the parts you mentioned I would use an OEM oil pump. Lot more tolerance sensitive than the top end I would suspect.

Thank You Sponsors!