iDRY Vacuum Kilns

Sponsors:

Fabtek Harvester Computer

Started by logloper, December 11, 2011, 07:31:03 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

logloper

I found my problem. I was trying to cut the trees to close to the ground. Where the butt "flares" was contacting the metal houseing that holds the saw bar. This would not allow the saw to cut. I still tend to try cutting to low, but when i do I just slide the head up a few inches and then it cuts right through. I finished the week with no major breaks on this machine, so I was happy. My production is slowly comeing up, I am able to keep 1 skidder busy. With time, hopefully can do better.
    Thanks to everyone who replied to my questions. Its amazeing to me how I can ask a question and get so much help from people I dont even know.

Thank You Sponsors!