iDRY Vacuum Kilns

Sponsors:

Clark skidder 666B transmission problem

Started by VelmerD, August 07, 2018, 08:04:09 AM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

VelmerD

Looking for info on problem with Clark 666B it wont go into reverse, I'm getting ready to pull it but I noticed when you turn the machine to the left or right it makes a racket at the top of the tranny from the PTO shaft going to the winch. I thought it was the PTO shaft itself making the noise (loose spline on shaft) I put a pry bar on the yolk coming out of tranny and there was a little bit of play. Would this cause the reverse clutch pack from engaging? This shaft runs in the center of the forward revers and HI,LOW clutch packs? Thanks for any insight on this

Thank You Sponsors!