The Forestry Forum is sponsored in part by:

iDRY Vacuum Kilns

Forestry Forum
Sponsored by:

TimberKing Sawmills

Toll Free 1-800-582-0470

LogRite Tools

Norwood Industries Inc.

Sawmill & Woodlot Magazine

Your source for Portable Sawmills, Edgers, Resaws, Sharpeners, Setters, Bandsaw Blades and Sawmill Parts

EZ Boardwalk Sawmills. More Saw For Less Money! sponsored by Northeast STIHL

Woodland Sawmills

Peterson Swingmills

 KASCO SharpTech WoodMaxx Blades


Sawmill Exchange

Michigan Firewood, your BRUTE FORCE Authorized Dealer


Council Tool

Baker Products


iDRY Wood Lumber Vacuum Drying for everyon

Author Topic: To cold to start  (Read 6377 times)

0 Members and 1 Guest are viewing this topic.

Offline junkyard

  • Full Member x2
  • ***
  • Posts: 168
  • Gender: Male
  • retired
    • Share Post
Re: To cold to start
« Reply #20 on: March 09, 2004, 08:14:53 AM »
On those old Cats once you got the pony motor warmed up you pulled the decompresion lever and started to turn the engine over. This got the lube oil loosened up. Never try to start before you had oil pressure then close decompressor and open throttle. Always shot of the gas on the pony motor and let it run dry otherwise thcarb float would bounce on rough ground and all of the gas went ito the base.
If it's free, It's for me. If for pay, leave it lay.

Share via delicious Share via digg Share via facebook Share via linkedin Share via pinterest Share via reddit Share via stumble Share via tumblr Share via twitter

Saw would not start when its cold!!

Started by minesmoria on Chainsaws

9 Replies
Last post January 18, 2005, 10:45:19 AM
by beenthere
deutz oem cold start?

Started by pinefeller on Forestry and Logging

31 Replies
Last post March 17, 2017, 07:57:38 PM
by pinefeller
648 cold weather start

Started by timberjack 450 on Forestry and Logging

3 Replies
Last post February 19, 2015, 02:44:05 PM
by jnicol6600
Detroit cold start

Started by Maine logger88 on Forestry and Logging

73 Replies
Last post January 08, 2014, 04:54:07 PM
by Woodboogah

Powered by EzPortal