The Forestry Forum is sponsored in part by:

iDRY Vacuum Kilns


Forestry Forum
Sponsored by:


TimberKing Sawmills



Toll Free 1-800-582-0470

LogRite Tools



Norwood Industries Inc.




Your source for Portable Sawmills, Edgers, Resaws, Sharpeners, Setters, Bandsaw Blades and Sawmill Parts

EZ Boardwalk Sawmills. More Saw For Less Money!

STIHLDealers.com sponsored by Northeast STIHL


Woodland Sawmills

Peterson Swingmills

 KASCO SharpTech WoodMaxx Blades

Turbosawmill

Sawmill Exchange

Michigan Firewood, your BRUTE FORCE Authorized Dealer

FARMA


Baker Products

ECHO-Bearcat

iDRY Wood Lumber Vacuum Drying for everyon

Baltic Abrasives Technologies Nyle Kiln Dry Systems




Author Topic: Kinda chainsaw  same motor  (Read 1603 times)

0 Members and 1 Guest are viewing this topic.

Offline JD_Kid

  • Full Member x2
  • ***
  • Posts: 155
  • Age: 49
  • Gender: Male
  • CAS shooter
    • Share Post
Kinda chainsaw  same motor
« on: October 29, 2004, 11:04:33 PM »
Hi ya's
now i have a small prob ..i found a older mister blower in a shed  a Stihl SR17  (CC rateing i don't know  a guess about 35-45)cleaned it up and tryed to start it  but no spark ..try the plug in a scrub cutter  and it works ...fuel getting to all the right places but no go ...plug will end up wet after a few pull's  :-/ ...can't seem to find a kill/earth switch  tho  ??? any ideas ..i know the rings are a bit tired too as the presure is a bit low but i feel it's still high eneff to run   ..did the older stihls have a kill/earth switch ?? if not any tricks of the trade
thanks
JD Kid
I used to smoke camels but found them hard to light and kicked to much


Share via delicious Share via digg Share via facebook Share via linkedin Share via pinterest Share via reddit Share via stumble Share via tumblr Share via twitter

xx
Poll:  11-8-04  Chainsaw ownership

Started by Ron Wenrich on Poll Archive

0 Replies
927 Views
Last post November 07, 2004, 05:41:43 PM
by Ron Wenrich
xx
"Old Man's "  ramblings.....kinda long.......

Started by timberbeast on General Board

3 Replies
1144 Views
Last post April 24, 2002, 05:12:46 PM
by Tom
xx
PTO circle mill  Good or Bad  ?  

Started by WV_hillbilly on Sawmills and Milling

67 Replies
13809 Views
Last post January 08, 2005, 11:43:56 AM
by Buzz-sawyer
xx
Wood-Mizer  4 deg  blades  ?

Started by Ohio_Bill on Sawmills and Milling

6 Replies
2164 Views
Last post January 11, 2003, 07:56:47 PM
by Bro. Noble
 


Powered by EzPortal