The Forestry Forum is sponsored in part by:

iDRY Vacuum Kilns


Forestry Forum
Sponsored by:


TimberKing Sawmills



Toll Free 1-800-582-0470

LogRite Tools



Norwood Industries Inc.




Your source for Portable Sawmills, Edgers, Resaws, Sharpeners, Setters, Bandsaw Blades and Sawmill Parts

EZ Boardwalk Sawmills. More Saw For Less Money!

STIHLDealers.com sponsored by Northeast STIHL


Woodland Sawmills

Peterson Swingmills

 KASCO SharpTech WoodMaxx Blades

Turbosawmill

Sawmill Exchange

Michigan Firewood, your BRUTE FORCE Authorized Dealer

FARMA


Baker Products

ECHO-Bearcat

iDRY Wood Lumber Vacuum Drying for everyon

Nyle Kiln Dry Systems




Author Topic: learning  (Read 406 times)

0 Members and 1 Guest are viewing this topic.

Offline coxy

  • Senior Member x2
  • *****
  • Posts: 6273
  • Age: 48
  • Location: eastern n.y
  • Gender: Male
    • Share Post
learning
« on: May 06, 2017, 08:33:23 PM »
experience took the motor and tranny out of the old 440 thats been sitting for the last 12 years those trannys are a pain in the ars to get out the steering pump was also a night mare with all the hydro lines that go to that  >:(  have to figure out what I'm doing with the other parts is the motor the same as a 450 dozer non turbo  a friend wants the tranny  also are the winch pumps from a 3325 the same as a 3315

Offline snowstorm

  • Senior Member x2
  • *****
  • Posts: 3942
  • Location: maine
  • Gender: Male
    • Share Post
Re: learning
« Reply #1 on: May 06, 2017, 09:08:50 PM »
440a used a 219 same as a 450 less the turbo the turbo motor has a oil cooler and lower compression pistons.the early 440 could be gas or diesel and was smaller than an a.


Share via delicious Share via digg Share via facebook Share via linkedin Share via pinterest Share via reddit Share via stumble Share via tumblr Share via twitter

xx
We're learning

Started by Ed_K on Sawmills and Milling

3 Replies
1256 Views
Last post July 20, 2003, 06:43:35 PM
by Ed_K
xx
learning to saw

Started by edgerman24 on Sawmills and Milling

29 Replies
2769 Views
Last post August 28, 2014, 08:18:50 AM
by Jeff
xx
Learning ones age! old now

Started by crowhill on General Board

13 Replies
763 Views
Last post August 11, 2019, 03:52:08 AM
by Ianab
xx
Learning as I go

Started by 123maxbars on Sawmills and Milling

3 Replies
751 Views
Last post October 24, 2012, 11:49:53 PM
by WDH
 


Powered by EzPortal