The Forestry Forum is sponsored in part by:

Forestry Forum
Sponsored by:

TimberKing Sawmills

Toll Free 1-800-582-0470

LogRite Tools

Norwood Industries Inc.

Sawmill & Woodlot Magazine

Your source for Portable Sawmills, Edgers, Resaws, Sharpeners, Setters, Bandsaw Blades and Sawmill Parts

EZ Boardwalk Sawmills. More Saw For Less Money! sponsored by Northeast STIHL

Woodland Sawmills

Peterson Swingmills

 KASCO SharpTech WoodMaxx Blades


Sawmill Exchange

BRUTE FORCE Authorized Dealer

Woodshax Outdoor Vending Solutions


Council Tool

Baker Products



Author Topic: Need help, new control board for L200m  (Read 241 times)

0 Members and 1 Guest are viewing this topic.

Offline Raym

  • Full Member
  • **
  • Posts: 89
  • Age: 54
  • Location: Montpelier, Va
  • Gender: Male
    • Share Post
Need help, new control board for L200m
« on: May 28, 2017, 07:09:13 AM »
Looking for some holiday weekend help for L200m.
Ordered a new board for unit, the old one worked except moisture probes would not read and nyle said it was due to lightning).
Recieved new board but had to wait to receive new backplate. Recieved new backplate and have all wires connected properly.
When I turn on controller, (version 2.5) the display is different from old board and the only setting I can adjust is the wet and dry bulb settings. Moisture probes don't show up, can't enter wood group, can't enter final moisture. And none of the relays come on....heat, compressor, vent etc.....

Any help would be appreciated.
'14-LT40 super, nyle l200m kiln, vintage case 480E loader.

It's not the fool that askith, it's the fool that agreeith.

Share via delicious Share via digg Share via facebook Share via linkedin Share via pinterest Share via reddit Share via stumble Share via tumblr Share via twitter

Nyle L200M Questions

Started by logboy on Drying and Processing

0 Replies
Last post February 01, 2015, 02:57:03 PM
by logboy
Questions starting up a Nyle L200M

Started by WoodenHead on Drying and Processing

5 Replies
Last post February 01, 2015, 09:17:30 PM
by WoodenHead
Nyle L200M Setup in Kenya

Started by sbawazir on Drying and Processing

4 Replies
Last post September 16, 2017, 10:03:24 AM
by scsmith42
Power feed control board

Started by sparks on Sawmills and Milling

0 Replies
Last post August 18, 2016, 10:46:59 AM
by sparks

Powered by EzPortal