The Forestry Forum is sponsored in part by:

iDRY Vacuum Kilns

Forestry Forum
Sponsored by:

TimberKing Sawmills

Toll Free 1-800-582-0470

LogRite Tools

Norwood Industries Inc.

Your source for Portable Sawmills, Edgers, Resaws, Sharpeners, Setters, Bandsaw Blades and Sawmill Parts

EZ Boardwalk Sawmills. More Saw For Less Money! sponsored by Northeast STIHL

Woodland Sawmills

Peterson Swingmills

 KASCO SharpTech WoodMaxx Blades


Sawmill Exchange

Michigan Firewood, your BRUTE FORCE Authorized Dealer

Baker Products


iDRY Wood Lumber Vacuum Drying for everyon

Nyle Kiln Dry Systems

Chainsawr, The Worlds Largest Inventory of Chainsaw Parts

Smith Sawmill Service

Author Topic: bearings  (Read 867 times)

0 Members and 1 Guest are viewing this topic.

Offline kev

  • member
  • *
  • Posts: 27
  • Location: hartland new brunswick
  • I'm new!
    • Share Post
« on: May 08, 2009, 04:32:11 PM »
hi all on my woodmizer the idle side bearing is loose just wondering how some of you went about changing them have some idea on what has to be done .thanks


  • Senior Member x2
  • *****
  • Posts: 3048
  • Age: 60
  • Location: Wamego, Kansas
  • Gender: Male
  • Poor white Southern trash
    • Share Post
Re: bearings
« Reply #1 on: May 08, 2009, 07:23:49 PM »

  They always seem a little loose.  If it is not getting hot or making noise I would let it ride.   Mine has over 10,000 hours so you got a ways to go.  You can adjust the tracking abit to keep the blade tracking on the wheel right.  Not hot or making noise then lets get back to sawing.

Share via delicious Share via digg Share via facebook Share via linkedin Share via pinterest Share via reddit Share via stumble Share via tumblr Share via twitter

Sealed bearings or greasable bearings on blade guides

Started by fathead on Sawmills and Milling

43 Replies
Last post October 31, 2012, 08:22:34 AM
by Cypressstump
hot bearings

Started by millstead on Sawmills and Milling

9 Replies
Last post February 01, 2013, 10:29:02 AM
by thecfarm
83 wm lt 30 bearings

Started by brandonward6 on Sawmills and Milling

3 Replies
Last post January 12, 2019, 11:46:31 PM
by Crossroads
10-10 bearings

Started by MickMac on Chainsaws

0 Replies
Last post October 16, 2017, 03:20:43 PM
by MickMac

Powered by EzPortal