iDRY Vacuum Kilns

Sponsors:

Woodmizer LT30 blade guide arm making me crazy

Started by butterfingers, July 20, 2019, 09:55:49 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

butterfingers

Hello all....I finally got my 1990 LT30 out for the season today. I put on a few new parts and serviced the motor. I decided to do a full by the book alignment and all was going well until I got to the part of setting the blade guide arm parallel to the bed. The arm is about 3/16 low fully closed. When I turn the cam bolts to adjust it I can only raise it a very little amount before the bolts cam over and I run out of adjustment. It's like I don't have near enough adjustment and there is nothing on my book about this. The blade is parallel to the bed with the guides removed. Anyone experience anything like this before? Thanks

Thank You Sponsors!