The Forestry Forum is sponsored in part by:

iDRY Vacuum Kilns


Forestry Forum
Sponsored by:


TimberKing Sawmills



Toll Free 1-800-582-0470

LogRite Tools



Norwood Industries Inc.




Your source for Portable Sawmills, Edgers, Resaws, Sharpeners, Setters, Bandsaw Blades and Sawmill Parts

EZ Boardwalk Sawmills. More Saw For Less Money!

STIHLDealers.com sponsored by Northeast STIHL


Woodland Sawmills

Peterson Swingmills

 KASCO SharpTech WoodMaxx Blades

Turbosawmill

Sawmill Exchange

Michigan Firewood, your BRUTE FORCE Authorized Dealer

Baker Products

ECHO-Bearcat

iDRY Wood Lumber Vacuum Drying for everyon

Nyle Kiln Dry Systems

Chainsawr, The Worlds Largest Inventory of Chainsaw Parts

Smith Sawmill Service



Author Topic: Another Bathroom Vanity  (Read 416 times)

0 Members and 1 Guest are viewing this topic.

Offline DWyatt

  • Senior Member
  • ****
  • Posts: 460
  • Age: 28
  • Location: NW Ohio
  • Gender: Male
    • Share Post
Another Bathroom Vanity
« on: July 26, 2021, 11:33:24 AM »
The main bathroom vanity is in the works. This one is 6'-6" long and will have a double sink and like the last one, it will have a cabinet that sits on the countertop. The wood is QS white Oak (Burr Oak) that Dad and I cut down at his house then sawed and dried last year. Here's a few pictures from this weekend. I am spraying these boxes this evening and they have to be installed by Thursday when they come to measure for countertops. Doors and drawers will be installed after.

Here's the main part of the cabinet, with the supports for the undermount drawer slides. The case it all built out of 3/4" maple plywood and the cabinet has a wall on each end so no finished end panels.





Here's the upper cabinet, it is 4' tall, 18" wide and 14" deep



 

I had a local shop mix up the stain. It is a pain. Goes on like mud, dries too quick, and has a tendency to look blotchy if you don't get it wiped off right away.



 

But this wood speaks for itself. Here is the panel for the door of the top cabinet after stain, it has the best figure. I tried my best to grain match for the glue ups on the panels, most of them look real nice, but it's hard to grain match this QS wood.




Offline firefighter ontheside

  • Senior Member x2
  • *****
  • Posts: 2999
  • Age: 47
  • Location: DeSoto MO
  • Gender: Male
  • I like trees.
    • Share Post
Re: Another Bathroom Vanity
« Reply #1 on: July 26, 2021, 05:04:38 PM »
Very nice.  I love the QS panels.
Woodmizer LT15
Kubota Grand L4200
Stihl 025 and MS291
2017 F350 Diesel 4WD
Kawasaki Mule 4010

Offline DWyatt

  • Senior Member
  • ****
  • Posts: 460
  • Age: 28
  • Location: NW Ohio
  • Gender: Male
    • Share Post
Re: Another Bathroom Vanity
« Reply #2 on: July 27, 2021, 08:01:24 AM »
@firefighter ontheside  Thank You. I took a lot of time cutting out only rift sawn wood for the rail and stiles and trying the maximize the QS wood for the panels. I personally prefer the look that way.

Offline DWyatt

  • Senior Member
  • ****
  • Posts: 460
  • Age: 28
  • Location: NW Ohio
  • Gender: Male
    • Share Post
Re: Another Bathroom Vanity
« Reply #3 on: July 27, 2021, 08:07:22 AM »
I got the main cabinets sprayed last night and tonight will be installing the drawer glides. Then tomorrow the cabinet has to be installed so they can measure for countertops Thursday, this week may be the death of me. I just got word from my builder that I may have to be the one to install the kitchen cabinets as well, tomorrow :o

Anywho, here's a couple pictures of the upper cabinet after finish. I use a SW precat lacquer, dull rubbed finish.


 




 



Share via delicious Share via digg Share via facebook Share via linkedin Share via pinterest Share via reddit Share via stumble Share via tumblr Share via twitter

xx
Osage Orange bathroom vanity

Started by Kcwoodbutcher on General Woodworking

24 Replies
5451 Views
Last post September 21, 2015, 03:38:57 PM
by Kcwoodbutcher
xx
Barnwood Vanity

Started by Brad_bb on General Woodworking

8 Replies
1440 Views
Last post August 11, 2017, 10:33:12 PM
by DPatton
xx
Vanity License Plates

Started by DR_Buck on General Board

36 Replies
8630 Views
Last post December 30, 2007, 05:28:38 PM
by isawlogs
xx
Backyard Wild Cherry Vanity

Started by 21incher on General Woodworking

12 Replies
753 Views
Last post March 14, 2020, 09:02:45 AM
by 21incher
 


Powered by EzPortal