iDRY Vacuum Kilns

Sponsors:

011 oiler

Started by auger creek, November 17, 2014, 09:38:16 AM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

auger creek

My 011 Sthil oiler will not oil. I've rebuilt it (new kit) hose looks good still no oiling to the bar. What's next?
021&025 Stihl sawsshop made 1/2 size skider shop made wood processor

T Welsh

try mixing gas and oil together and putting it in the tank and see if it comes back to life. the lower viscosity is easier for it to pump and is always the quick fix out in the field when one of ours stops pumping oil,take the bar off and run it for a few minutes and see what happens! Remember to drain the tank after doing this!!
Seems like the 011 is a diagram type pump http://www.smaf-touseau.com/doc/102  You may need to get a rebuild kit for it being its that old! Also look for clogged lines and blow these out with compressed air to make sure they are not restricted. Good luck,Tim 

auger creek

You saved my bacon!!! works like a new saw did. 8)
021&025 Stihl sawsshop made 1/2 size skider shop made wood processor

Thank You Sponsors!