iDRY Vacuum Kilns

Sponsors:

Poland Woodshark 1800

Started by mr_ed, March 01, 2009, 04:08:55 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

mr_ed

I need some Pro advice on my little top handle Poland Woodshark 1800

The chain oiler stopped working. Where do I need to look and what do I need to look for that could stop the bar from oiling. I am pretty sure it is a pressurized tank oiler system.
Is this a fairly easy fix?

Thanks in advance  Mr. Ed

ComputerUser


Kevin


Kevin

You should be able to pull the clutch, take the oil pump apart and check the valve.

mr_ed

Poulan Sorry for the spelling.

Thanks Kevin. Is the pump behind the plate (clutch side of saw)with the two screws?

sawmilllawyer

Take the side cover off, remove the spocket, and the oiler is held inplace by the two screws you talking about. Remove them and you should be able to remove the oiler. Usually they are plastic and cost about $20.00 or less. You can order via the 1-800 number on the saw. They sell a small plastic installation tool for a couple of bucks, but it and use it to install the new oiler. Been there done that and my 2150 still screams for a homeowner saw.
Stihl MS-361, MS-460 mag, Poulan 2150, 2375 Wildthing.

mr_ed

Thanks sawmilllawyer,I thought that was it but not sure.
Mr Ed.

Thank You Sponsors!