iDRY Vacuum Kilns

Sponsors:

Toeboard travel?

Started by Satamax, August 17, 2022, 12:51:18 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

jpassardi

We had those on the alignment rack where I used to work. They have mechanical detent locks about every 3/4" as I recall. Hunter Engineering makes top end equipment.
LT15 W/Trailer, Log Turner, Power Feed & up/down
CAT 416 Backhoe W/ Self Built Hydraulic Thumb and Forks
Husky 372XP, 550XPG, 60, 50,   WM CBN Sharpener & Setter
40K # Excavator, Bobcat 763, Kubota RTV 900
Orlan Wood Gasification Boiler -Slab Disposer

Satamax

Quote from: jpassardi on August 25, 2022, 07:12:34 AM
We had those on the alignment rack where I used to work. They have mechanical detent locks about every 3/4" as I recall. Hunter Engineering makes top end equipment.
That's good to know. 
Thanks. 
French CD4 sawmill. Latil TL 73. Self moving hydraulic crane. Iveco daily 4x4 lwb dead as of 06/2020. Replaced by a Brimont TL80 CSA.

Satamax

Quote from: jpassardi on August 25, 2022, 07:12:34 AM
We had those on the alignment rack where I used to work. They have mechanical detent locks about every 3/4" as I recall. Hunter Engineering makes top end equipment.
I checked today on mine. First detent is 5cm or 2 inches, second one 2 inches above too, and third one is 6.5 cm or about 2.5 inches above. That's latched on the metal stops, with air removed. So 6.5 total travel. 
@Fluidpowerpro, since those are metal on metal detents or latches, i might not have too much bouncing problems.  ;D
French CD4 sawmill. Latil TL 73. Self moving hydraulic crane. Iveco daily 4x4 lwb dead as of 06/2020. Replaced by a Brimont TL80 CSA.

Thank You Sponsors!