iDRY Vacuum Kilns

Sponsors:

Reina's New Toy

Started by Fla._Deadheader, January 30, 2007, 04:33:15 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages 1 2 All
User actions

Tom

#25
February 05, 2007, 09:13:08 PM
The plans I saw weren't plywood.   Y0u made the wheel by creating your own.  I think it was 3 layers of boards at different angles. glued and screwed and fiberglassed.

It wasnt' a little saw either.  The wheels were in the 25 or 30 inch range.

Furby

#26
February 05, 2007, 09:38:40 PM
Wouldn't worry about making your own plywood if that hardwood is as hard as you say, I'd figure it would hold together just fine as one piece. Could be wrong though. :)

SwampDonkey

#27
February 06, 2007, 06:05:49 AM
All ya need is one of them big logs and a really big lathe. Just cut off a couple feet of log, mount her, get out the scraper to get her nice and round, dismount and slice off a couple new band wheels. Drill a centre hole to fit the drive mechanism. Apply some 2-in-1 epoxy and some rubber, set and mount. Good to go. Easy ain't it? ;D
"No amount of belief makes something a fact." James Randi

1 Thessalonians 5:21

2020 Polaris Ranger 570 to forward firewood, Husqvarna 555 XT Pro, Stihl FS560 clearing saw and continuously thinning my ground, on the side. Grow them trees. (((o)))
Print
Go Up Pages 1 2 All
User actions

Thank You Sponsors!