iDRY Vacuum Kilns

Sponsors:

Time 2 Stir The Pot! A Huztl Kit Saw & Husqvarna 288, 390, and 365 48mm Popup

Started by weimedog, March 28, 2020, 07:49:12 AM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

weimedog

Some UGLY Cookies! Needed a reason to run saws. And then all chit hit the fan as I need fire wood and to test a few saws. Specifically a 288 and 390. My "Bling Saw" has been sitting for a while and my Go To saw has been for a while this blend of crap 365 ( BOC365?? ). Has a Huztl Tank/Handle, Huztl set of cases with Nachi Bearings, Huztl seals. Has a VEC 48mm popup in an OEM used cylinder tied to an OEM crank. A used carb from an X-torq 372 on a OEM intake boot. OEM X-Torq ignition. A junk pile saw but it runs....well. :) Everything not mentioned are bones from a dead OEM 372 X-Torq

https://www.youtube.com/watch?v=7bfWeFmTNRU
Husqvarna 365sp/372xpw Blend, Jonsered 2171 51.4mm XPW build,562xp HTSS, 560 HTSS, 272XP, 61/272XP, 555, 257, 242, 238, Homelite S-XL 925, XP-1020A, Super XL (Dad's saw); Jonsered 2094, Three 920's, CS-2172, Solo 603; 3 Huztl MS660's (2 54mm and 1 56mm)

Thank You Sponsors!