iDRY Vacuum Kilns

Sponsors:

361 carb limiter caps

Started by boboak, February 25, 2007, 07:45:17 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

boboak

  What's the best way to get to the 361 limiter caps and what's the procedure after that? I'd like to be able to fine tune the carb a little better than I can now. Will the carb stay in ajustment with the caps removed or is this going to be an on-going hassle every time I need to re-tune?   Thanks....Bob
Sometimes you get things done faster if you do them slower

sawguy21

I am not going to tell you to do it but lots of people carefully grind the ears off the caps. The screws won't stay in place with the caps removed.
old age and treachery will always overcome youth and enthusiasm

Thank You Sponsors!