iDRY Vacuum Kilns

Sponsors:

Enclosed Trailers: Tips and tricks? Outfitting?

Started by Old Greenhorn, March 10, 2024, 06:43:46 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Ljohnsaw

Hopefully you didn't get your reflective tape at HF!  I got some a while back.  The red fades in 1 year out here and the sticky gave up in the second year smiley_thumbsdown
John Sawicky

Just North-East of Sacramento...

SkyTrak 9038
Ford 545D FEL
Genie S45
Davis Little Monster backhoe
Case 16+4 Trencher
Home Built 42" capacity/36" cut Bandmill up to 54' long - using it all to build a timber frame cabin.

Old Greenhorn

Nah, I didn't even know HF had it. I got mine form Etrailer and it's DOT type stuff. Similar to what we used on fore trucks. I don't know yet if ti will fade but the sticky on that is not likely to give up soon, I had a hard time getting it off my fingers.:) 
Tom Lindtveit, Woodsman Forest Products
Oscar 328 Band Mill, Husky 350, 450, 562, & 372 (Clone), Mule 3010, and too many hand tools. :) Retired and trying to make a living to stay that way. NYLT Certified.
OK, maybe I'm the woodcutter now.
I work with wood, There is a rumor I might be a woodworker.

Old Greenhorn

Just went back and read this whole thread and realized I (we?) never finished it. I've been using it near 4 months now and it's doing well. That idea I had to strap benches to the sidewall was a bad one. (Doc was right.)  I made a rack that held the benches top to top with small stools nested where they fit, this brought the density for the same space way up by about a factor of 4. Everything else is working very well for shows. I barely use the battery, but the lights are handy. The shoreline hookup is also great to have because I put a 110v fan in the roof vent to keep air moving during the summer days at home with the door cracked open, it also keeps the battery maintained. All the other improvements have worked out except cutting the d-rings, most are ok, but one got stretched and broken. I'll switch that back to a d-ring soon.
 I would like to improve the packing density, but that is so dependent on product size/shape it becomes very hard to get too much better. I keep looking at it every week though with an open mind. I am kind of waiting for one oddball item to sell, then I can re-do a wall section, I think.
 I still have not replaced the bearings, but all the shows I have done are less than 20 miles away, so short trips. I do have the bearings in the trailer anyway. I don't think I need stabilizer jacks or a solar charger as I thought earlier in the game. I will re-think when the season is over in October.
 But, for the most part, with all the good advice I got here, it is working out well.
Tom Lindtveit, Woodsman Forest Products
Oscar 328 Band Mill, Husky 350, 450, 562, & 372 (Clone), Mule 3010, and too many hand tools. :) Retired and trying to make a living to stay that way. NYLT Certified.
OK, maybe I'm the woodcutter now.
I work with wood, There is a rumor I might be a woodworker.

beenthere

You are in control of the design specs, so making them to fit the trailer space for better packing density, comes to mind.  :wink_2: :wink_2:
south central Wisconsin
It may be that my sole purpose in life is simply to serve as a warning to others

Thank You Sponsors!