iDRY Vacuum Kilns

Sponsors:

Pallets

Started by Peter Drouin, April 22, 2016, 06:05:25 AM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages1
User actions

Peter Drouin

April 22, 2016, 06:05:25 AM
I have tried with 1" and 2" with mix results.  When John bumps them, it's not good.



  

 

16d will pull out. So I'm going to try ¼x4" lags and 4x4.


  

  

 

I left out the bottom 2x to give more room.. Will see if this will work better.

Also had to replace a cable on John for the clutch to work, all good now.


 
A&P saw Mill LLC.
45' of Wood Mizer, cutting since 1987.
License NH softwood grader.

thecfarm

#1
April 22, 2016, 06:26:49 AM
Maybe you need a smaller John.   ;D  I know,a smaller John would not lift as much.
I know hardwood cost more,but would it hold up better. Too bad you don't have a bunch of metal kicking around. Than John would stop breaking,and start bending.  ;D
Model 6020-20hp Manual Thomas bandsaw,TC40A 4wd 40 hp New Holland tractor, 450 Norse Winch, Heatmor 400 OWB,YCC 1978-79

Bruno of NH

#2
April 22, 2016, 07:03:04 AM
Peter
Try the GRK screws and lags they hold great and can be drivin with a cordless drill .
Bruno
Lt 40 wide with 38hp gas and command controls , F350 4x4 dump and lot of contracting tools

Dave Shepard

#3
April 22, 2016, 08:54:51 AM
+2 on the GRK RSS lags.
Wood-Mizer LT40HDD51-WR Wireless, Kubota L48, Honda Rincon 650, TJ208 G-S, and a 60"LogRite!

Peter Drouin

#4
April 22, 2016, 08:46:58 PM
I think the GRK is 2x the money


Cfarm, I have a pile of 6' fence post. ;)
A&P saw Mill LLC.
45' of Wood Mizer, cutting since 1987.
License NH softwood grader.
Print
Go Up Pages1
User actions

Thank You Sponsors!