The Forestry Forum is sponsored in part by:

iDRY Vacuum Kilns


Forestry Forum
Sponsored by:

TimberKing Sawmills

Toll Free 1-800-582-0470

LogRite Tools

Norwood Industries Inc.

Your source for Portable Sawmills, Edgers, Resaws, Sharpeners, Setters, Bandsaw Blades and Sawmill Parts

EZ Boardwalk Sawmills. More Saw For Less Money!

Woodland Sawmills

Peterson Swingmills


Michigan Firewood, your BRUTE FORCE Authorized Dealer

Baker Products


iDRY Wood Lumber Vacuum Drying for everyon

Nyle Kiln Dry Systems

Chainsawr, The Worlds Largest Inventory of Chainsaw Parts

Smith Sawmill Service

Author Topic: New Mill Owner Questions  (Read 3431 times)

0 Members and 1 Guest are viewing this topic.

Offline plaindriver

  • Full Member
  • **
  • Posts: 97
  • Age: 72
  • Location: Crossville, Tn. on the Cumberland Plateau
  • Gender: Male
    • Share Post
New Mill Owner Questions
« on: July 03, 2013, 10:57:27 AM »
Neil, I just finished assembling my new Woodlands Mill. Almost everything is fine, except a few minor problems. The roller pin on the rt. cam lock for the head came out. In the sawdust somewhere. I temp replaced with a small screw/nut. The parts package was short (2) #10 nuts, tho there were about 8 extra M10x25 bolts.
But most importantly: your video on the 2013 mill shows a locking up-down head crank, where mine looks different, and has no locking mechanism. It has a tendency to vibrate lower during the cut. Is there a locking crank? Sure would be helpful.

Side note: I installed an Hr meter to track maint intervals. Cost about $10 on ebay. I mounted it to the lower lt of the motor.



Kubota L4600 DT w/FEL, John Deere 750 4WD w/FEL, PH Digger,RotoTiller,Box Scraper,Disc;16, 18, 20" chainsaws;Troy Built 27T splitter; table saw, radial arm saw,turning lathe, chipper, small backhoe, Isuzu NPR 14' stakeside diesel truck; a wife that still likes me.

Offline NeilB

  • Board Moderator
  • *****
  • Posts: 42
  • Location: Ontario, Canada
  • Gender: Male
    • Share Post
    • Woodland Portable Sawmills
Re: New Mill Owner Questions
« Reply #1 on: July 08, 2013, 11:18:28 AM »
Just saw this... getting parts UPS'd out as discussed earlier...
Neil B
Woodland Mills

Share via delicious Share via digg Share via facebook Share via linkedin Share via pinterest Share via reddit Share via stumble Share via tumblr Share via twitter



Powered by EzPortal