Woomizer blade guides

[Jason_WI]

I am looking for the part number for the roll guide used on WM LT40 and smaller mills. I just need the roller and bearing. I looked at these close up at the 25 Anneversary show in Wausau. The WM rollers have a higher back lip than the ones on the LM2000 From Norwood. I find that after 100 hours the LM rollers are get a rounded edge and the blade jumps off the roller real easy. With the WM roller the chance of that happening looks to be a lot less.

Jason

[Bibbyman]

A04925