The Forestry Forum is sponsored in part by:

iDRY Vacuum Kilns

Forestry Forum
Sponsored by:

TimberKing Sawmills

Toll Free 1-800-582-0470

LogRite Tools

Norwood Industries Inc.

Your source for Portable Sawmills, Edgers, Resaws, Sharpeners, Setters, Bandsaw Blades and Sawmill Parts

EZ Boardwalk Sawmills. More Saw For Less Money! sponsored by Northeast STIHL

Woodland Sawmills

Peterson Swingmills

 KASCO SharpTech WoodMaxx Blades


Sawmill Exchange

Michigan Firewood, your BRUTE FORCE Authorized Dealer

Baker Products


iDRY Wood Lumber Vacuum Drying for everyon

Nyle Kiln Dry Systems

Chainsawr, The Worlds Largest Inventory of Chainsaw Parts

Smith Sawmill Service

Author Topic: Husqvarna 562xp West Coast or East Coast Setup?  (Read 2071 times)

0 Members and 1 Guest are viewing this topic.

Offline weimedog

  • Senior Member x2
  • *****
  • Posts: 1595
  • Location: CNY
  • Gender: Male
  • Better to be a "Has Been" than a "Never Been"!
    • Share Post
Re: Husqvarna 562xp West Coast or East Coast Setup?
« Reply #40 on: August 23, 2021, 11:43:58 PM »
Typical Day Getting Firewood.... Imagine Using A big Heavy saw here if u will.

Husqvarna 365sp/372xpw Blend, Jonsered 2171 51.4mm XPW build,562xp HTSS, 560 HTSS, 272XP, 61/272XP, 555, 257, 242, 238, Homelite S-XL 925, XP-1020A, Super XL (Dad's saw); Jonsered 2094, Three 920's, CS-2172, Solo 603; 3 Huztl MS660's (2 54mm and 1 56mm)

Share via delicious Share via digg Share via facebook Share via linkedin Share via pinterest Share via reddit Share via stumble Share via tumblr Share via twitter

West vs. East Coast Mills

Started by NWwoodsman on Forestry and Logging

9 Replies
Last post February 02, 2010, 05:54:16 AM
by SwampDonkey
West coast saw doc

Started by CALSAW on Sawmills and Milling

3 Replies
Last post December 01, 2007, 08:02:57 PM
by olyman
West coast of MI

Started by Furby on Travel Guide

10 Replies
Last post September 19, 2006, 08:11:31 PM
by SwampDonkey
From the West Coast

Started by ErikC on General Board

18 Replies
Last post November 30, 2008, 11:28:01 PM
by solodan

Powered by EzPortal