Husky auto tune saws

[Owtlaw]

If you don't run your saw hard enough during the initial auto tune calibration, do you need to have the computer reset by the dealer or will it automatically recalibrate?

[sawguy21]

@Spike60 

[Spike60]

You can run them in anytime, new or old. Not so much a matter of running iy hard, as running it long. One continueous cut along a log, bat tip about 4" in, for 30-60 seconds. If it's off a lot, you'll actually hear it reset. I was doing some rip cuts on 20-20" oak yesterday, and I suppose they were of long enough duration also.

The lo speed is set simply by letting it idle. The lo doesn't sample as frequently as the hi, so I think it has ti idle for 3 minutes.

[Owtlaw]

Thank you for the response.  That is good to know.