The Forestry Forum is sponsored in part by:

iDRY Vacuum Kilns

Forestry Forum
Sponsored by:

TimberKing Sawmills

Toll Free 1-800-582-0470

LogRite Tools

Norwood Industries Inc.

Your source for Portable Sawmills, Edgers, Resaws, Sharpeners, Setters, Bandsaw Blades and Sawmill Parts

EZ Boardwalk Sawmills. More Saw For Less Money! sponsored by Northeast STIHL

Woodland Sawmills

Peterson Swingmills

 KASCO SharpTech WoodMaxx Blades


Sawmill Exchange

Michigan Firewood, your BRUTE FORCE Authorized Dealer

Baker Products


iDRY Wood Lumber Vacuum Drying for everyon

Nyle Kiln Dry Systems

Chainsawr, The Worlds Largest Inventory of Chainsaw Parts

Smith Sawmill Service

Author Topic: 021 needs leanin  (Read 2054 times)

0 Members and 1 Guest are viewing this topic.

Offline Whistler

  • member
  • *
  • Posts: 4
  • I need to edit my profile!
    • Share Post
021 needs leanin
« on: January 25, 2002, 04:35:24 PM »
Hello Boys;  My  son's saw desperately needs some top end performance but the high jet is unaccessable .  How do you get that plastic block out of there and then , is there a high jet waiting for me ?

Offline Whistler

  • member
  • *
  • Posts: 4
  • I need to edit my profile!
    • Share Post
Re: 021 needs leanin
« Reply #1 on: January 25, 2002, 04:37:04 PM »
 Oops, I meant 026 Pro, sorry.

Offline Kevin

  • Senior Member x2
  • *****
  • Posts: 6651
  • Age: 67
  • Gender: Male
    • Share Post
Re: 021 needs leanin
« Reply #2 on: January 29, 2002, 04:35:32 PM »
Don`t worry Jeff, I`ll look after him.  

Your Mentor.

Offline timberbeast

  • Senior Member
  • ****
  • Posts: 360
  • Gender: Male
  • I Got nothin' to say :o)
    • Share Post
    • Timber Buyers Network Contact Page
Re: 021 needs leanin
« Reply #3 on: January 30, 2002, 01:01:57 AM »
Plastic block?  I don't quite get that,  I have 3 Stihls,  and all three adjust the same,  there is a high adjust (controls how high it'll rev),  a low (to keep the saw running when trigger is not depressed)  and idle (keeps the chain from turning in idle).
If you don't have a screwdriver small enough to fit inside the rubber housing,  just take off the air-cleaner cover and pull off the rubber grommet.  Just don't lean it out too much,  or you could exceed max rpm's.  Wash or replace the air cleaner at the same time (could be the problem).  When you adjust either the high or low,  check the idle to make sure your chain isn't turning in idle.  Or else,  you saw is a lot newer or older than mine are.
Where the heck is my axe???

Share via delicious Share via digg Share via facebook Share via linkedin Share via pinterest Share via reddit Share via stumble Share via tumblr Share via twitter

Powered by EzPortal