Author Topic: Accuset2 Setworks question? (Read 942 times)

038magnum · « **on:** October 20, 2012, 12:43:31 PM »

I have been playing some with my new mill cutting 1 1/8" boards. I had Accuset programed with the correct kerf for the blade that I am using. The mill started out cutting 1 1/8" thick. next day it was 1 3/16". Now it is cutting 1 1/4". What might be causing this?

Bibbyman · « **Reply #1 on:** October 20, 2012, 12:59:31 PM »

Just occasionally? Or every board?

I'd say a conversation with Sparks at Wood-Mizer would get you back on track quicker.

I've never had that happen.

rmack · « **Reply #2 on:** October 20, 2012, 02:28:39 PM »

2 cents from the uneducated... sounds like a reference point moving.

Does your bottom of low tooth to deck measurement still jive?

terrifictimbersllc · « **Reply #3 on:** October 20, 2012, 04:36:19 PM »

.....and have you ruled out the cant moving from stress, this throws board thicknesses all over the place (usually ends thinner and middles thicker).

038magnum · « **Reply #4 on:** October 20, 2012, 06:45:37 PM »

Thanks for the advice. I will play more with it tomorrow.

Forestry Forum
Sponsored by: