The Forestry Forum is sponsored in part by:

iDRY Vacuum Kilns

Forestry Forum
Sponsored by:

TimberKing Sawmills

Toll Free 1-800-582-0470

LogRite Tools

Norwood Industries Inc.

Your source for Portable Sawmills, Edgers, Resaws, Sharpeners, Setters, Bandsaw Blades and Sawmill Parts

EZ Boardwalk Sawmills. More Saw For Less Money! sponsored by Northeast STIHL

Woodland Sawmills

Peterson Swingmills

 KASCO SharpTech WoodMaxx Blades


Sawmill Exchange

Michigan Firewood, your BRUTE FORCE Authorized Dealer

Baker Products


iDRY Wood Lumber Vacuum Drying for everyon

Nyle Kiln Dry Systems

Chainsawr, The Worlds Largest Inventory of Chainsaw Parts

Smith Sawmill Service

Author Topic: Care of transplanted Holly trees?  (Read 708 times)

0 Members and 1 Guest are viewing this topic.

Offline gspren

  • Senior Member x2
  • *****
  • Posts: 2761
  • Age: 71
  • Location: Brogue, PA & Fenwick, DE
  • Gender: Male
    • Share Post
Care of transplanted Holly trees?
« on: November 02, 2021, 10:13:19 PM »
Yesterday I dug up some 18" to 30" Hollys out of my woods and replanted in my new woods about 8 mile away so they were only out of the ground an hour or so. The dirt where I put them isn't the best so I mixed in a little peat moss. It rained most of today and it's going to get cold later this week, should I mulch around them with straw to hold in some ground heat, do something else, or just let nature take over?
Stihl 041, 044 & 261, Kubota 400 RTV, Kubota BX 2670, Ferris Zero turn

Share via delicious Share via digg Share via facebook Share via linkedin Share via pinterest Share via reddit Share via stumble Share via tumblr Share via twitter

So how come the leaves on my holly trees aren't turning?

Started by Dan_Shade on General Board

4 Replies
Last post November 09, 2005, 08:42:48 AM
by farmerdoug
Holly Daze - biggest holly log I've seen - now what?

Started by btulloh on Sawmills and Milling

12 Replies
Last post January 05, 2016, 09:31:47 AM
by Raym
Holly Waa

Started by chet on General Board

14 Replies
Last post October 18, 2007, 10:46:11 PM
by isawlogs

Started by Woodwalker on Sawmills and Milling

4 Replies
Last post December 23, 2008, 09:50:02 AM
by Texas Ranger

Powered by EzPortal