iDRY Vacuum Kilns

Sponsors:

Kohler 27 Hp governor

Started by ladylake, April 19, 2007, 06:45:24 AM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages1
User actions

ladylake

April 19, 2007, 06:45:24 AM
My Kohler has been over reving once in a while lately.(Seems like there was a post about that a while back)  Got to looking at the governor linkage which was pretty sticky. Oiled the whole linkage and was still sticky, I found the problem was a little rod that goes down into the carb with a rubber boot on it. (right side near the back) I pulled the boot off and oiled the rod, worked really smooth then.  Sawed yesterday, no more over reving.  Steve
Timberking B20  18000  hours +  Case75xt grapple + forks+8" snow bucket + dirt bucket   770 Oliver   Lots(too many) of chainsaws, Like the Echo saws and the Stihl and Husky     W5  Case loader   1  trailers  Wright sharpener     Suffolk  setter Volvo MCT125c skid loader

Captain

#1
April 19, 2007, 07:22:23 AM
Steve, that little grommet is the worst trouble spot whan the linkage gets a little dirty/corroded.  Great job on finding it.

Captain
Print
Go Up Pages1
User actions

Thank You Sponsors!