The Forestry Forum is sponsored in part by:

iDRY Vacuum Kilns


Forestry Forum
Sponsored by:


TimberKing Sawmills



Toll Free 1-800-582-0470

LogRite Tools



Norwood Industries Inc.




Your source for Portable Sawmills, Edgers, Resaws, Sharpeners, Setters, Bandsaw Blades and Sawmill Parts

EZ Boardwalk Sawmills. More Saw For Less Money!

STIHLDealers.com sponsored by Northeast STIHL


Woodland Sawmills

Peterson Swingmills

 KASCO SharpTech WoodMaxx Blades

Turbosawmill

Sawmill Exchange

Michigan Firewood, your BRUTE FORCE Authorized Dealer

Baker Products

ECHO-Bearcat

iDRY Wood Lumber Vacuum Drying for everyon

Nyle Kiln Dry Systems

Chainsawr, The Worlds Largest Inventory of Chainsaw Parts

Smith Sawmill Service



Author Topic: Blade Hammering  (Read 230 times)

0 Members and 1 Guest are viewing this topic.

Offline Bullheaded

  • Full Member
  • **
  • Posts: 55
  • Location: Western UP Michigan
  • Gender: Male
  • I'm new!
    • Share Post
Blade Hammering
« on: August 05, 2022, 06:59:12 PM »
I wanted to take the time relate what a great experience I had today at Moraska Saw in Powers, Michigan. I had talked to Mark (newer owner and former employee) last week on the phone asking if I could wait while he hammered my blade since it was a 250 mile round trip for me. He was very receptive to my being present for the whole process. What he said would take between an hour and two, was actually well over two hours as he took the time to explain in detail what and why he was doing at each phase. Its been a long time since I have had that in-depth
br> degree of customer service ANYWHERE. Being a retired toolmaker, I was completely fascinated at his ability to move the metal and make it behave as intended. I could tell that Mark was excited in having a couple young employees that were “apprenticing” the trade and carrying on the lost art. 

Offline moodnacreek

  • Senior Member x2
  • *****
  • Posts: 4186
  • Location: Orange County NY
  • Gender: Male
  • Sawin by the notches
    • Share Post
Re: Blade Hammering
« Reply #1 on: August 05, 2022, 09:13:39 PM »
They don't do many saws that small. I would dare say if you keep your teeth square and wide you will never hammer it again.


Share via delicious Share via digg Share via facebook Share via linkedin Share via pinterest Share via reddit Share via stumble Share via tumblr Share via twitter

xx
Hammering a saw blade....

Started by mrcaptainbob on Sawmills and Milling

7 Replies
4121 Views
Last post November 07, 2011, 07:08:43 AM
by bandmiller2
xx
Hammering a blade for rpm ??

Started by sjh on Sawmills and Milling

5 Replies
1814 Views
Last post September 29, 2003, 06:01:11 PM
by D._Frederick
xx
hammering a blade

Started by sawwood on Sawmills and Milling

3 Replies
438 Views
Last post February 16, 2020, 07:41:09 PM
by moodnacreek
question
Mobile Dimension blade runout & VA. hammering

Started by LKasdorf on Sawmills and Milling

2 Replies
1592 Views
Last post May 30, 2003, 09:06:11 PM
by see_saw
 


Powered by EzPortal