The Forestry Forum is sponsored in part by:

iDRY Vacuum Kilns


Forestry Forum
Sponsored by:


TimberKing Sawmills



Toll Free 1-800-582-0470

LogRite Tools



Norwood Industries Inc.




Your source for Portable Sawmills, Edgers, Resaws, Sharpeners, Setters, Bandsaw Blades and Sawmill Parts

EZ Boardwalk Sawmills. More Saw For Less Money!

STIHLDealers.com sponsored by Northeast STIHL


Woodland Sawmills

Peterson Swingmills

 KASCO SharpTech WoodMaxx Blades

Turbosawmill

Sawmill Exchange

Michigan Firewood, your BRUTE FORCE Authorized Dealer

Baker Products

ECHO-Bearcat

iDRY Wood Lumber Vacuum Drying for everyon

Nyle Kiln Dry Systems

Chainsawr, The Worlds Largest Inventory of Chainsaw Parts

Smith Sawmill Service



Author Topic: Steam Engine / Power Idea  (Read 3346 times)

0 Members and 1 Guest are viewing this topic.

Offline J-holden3285

  • Member*
  • *
  • Posts: 1
  • I'm new!
    • Share Post
Re: Steam Engine / Power Idea
« Reply #40 on: February 12, 2021, 09:24:43 PM »
Saw a you-tune video where a guy used a 12 volt pump to feed water into a heated copper coil to make a rather impressive steam cleaner. 6" piddly water flow until he heated the coil with propane, then a continuous 5 foot gusting steam output! Thought that the same setup heated with wood might be able to use the steam flow to power an air drill cranking an alternator for power (use a small percentage of the power to run the pump). Other than corrosion issues that I see as fixable, might this be a safe easy way to use wood heat for electricity?
In the late 80s I learned how to separate hydrogen from water I was in my teens and didnít know how dangerous it was I thought I could build a furnace to burn Iím very lucky that Iím here today lol but then I changed my ideas to steam I converted a old 8 hp Briggs to run on steam it actually worked I have thought about revisiting the idea again now that Iím old and understand steam concept a little better but I think steam has a place If you  have the resources and I think itís safer than people want to admit if you set your safety up and test them as you go.


Share via delicious Share via digg Share via facebook Share via linkedin Share via pinterest Share via reddit Share via stumble Share via tumblr Share via twitter

xx
New York Steam Engine Assoc. Pageant of Steam, Aug 11-14

Started by Brad_S. on Shows, Events and Places to meet

0 Replies
1311 Views
Last post July 15, 2005, 06:15:06 PM
by Brad_S.
question
Steam Power

Started by Cedar Eater on Sawmills and Milling

7 Replies
2417 Views
Last post April 11, 2002, 06:47:49 AM
by splinters
xx
Sawing with steam power

Started by ElectricAl on Sawmills and Milling

12 Replies
3165 Views
Last post September 03, 2002, 07:02:11 AM
by ElectricAl
xx
Glass steam engine

Started by Fraxinus on General Board

6 Replies
687 Views
Last post April 07, 2013, 10:09:56 PM
by Warbird
 


Powered by EzPortal