Started this job last Sunday when I got home from a small saw job. Working evenings when I had time and this morning I am finally ready to put it back together. Here is a pick of the pieces involved with getting this far.
(https://forestryforum.com/gallery/albums/userpics/11405/IMG_20190421_142010341.jpg?easyrotate_cache=1555871498)
A hint; I had to listen to the obnoxious noise all the way to the job and all the home.
In my past life I did this procedure countless times and even had other garages send me these jobs because I was so good at it. I never had one fight me as much as this one.
So what are the pieces from?
mh
Exhaust manifold bolts?
Correct! 4 broken studs. I had to drill one, the other three came out by welding on to the end of them.
mh
I just had mine done on my dakota. It's beyond my skill level and desire. That's probably one of the worst jobs you can do on a vehicle, no?
Had that done last year on my GMC 1500
It looks like you were "warming up" rusted bolts with the acetylene torch, and then hit the oxy lever. ;D
Quote from: Resonator on April 21, 2019, 05:51:30 PM
It looks like you were "warming up" rusted bolts with the acetylene torch, and then hit the oxy lever. ;D
No. I use a mig welder to "build up" a stud that is broken flush or recessed in the head. Then weld a bolt on to the build up. Usually break the weld off a few times before enough heat transfers to loosen the stud. Usually it takes 3 to 5 tries per stud. This time I did it over 30 times for the 4 studs, so approximately 8 welds per stud.
mh
If I am reading this correctly you are saying that you had a 650% failure rate.
Congratulations on getting 'er done.
Gerald
That's the way I roll :D :D
Wow.
My mother would have said you have the patience of Job.
Nice work. Knew what they were as soon as I saw them.
We do quite a few of those here at the shop. So far we've gotten them all out but always tell the customer we can't guarantee it. Worst one we had was a V10 Ford where 18 of the 20 studs broke off.
My dad is the go-to guy for that here. He never tries drilling anymore, just straight to the wire welder. For many years he's been welding big nuts to the broken off studs but a couple years ago someone suggested welding a washer on first and that's worked very well for him. It's easier to get a good weld with the washer as it gives better visibility and access for the tip of the welder. Then weld a nut to the washer.
Like you he has a lot of them twist off multiple times before they finally come out. He's always a little giddy when the last one is done.
Alan
I stopped trying to do that using nuts since it seems I could never get good penetration I usually use a piece of 1/4" flat plate with a hole drilled in it. I like the washer idea.
I thought it was a homemade stump grinder.🙂