iDRY Vacuum Kilns

Sponsors:

Bandit sp2100 engine belt

Started by 17inch, June 25, 2018, 01:24:23 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

17inch

Hi,
The engine belt snapped. On one end is a pulley and the other end has a hydraulic drive. Looks like I have to remove both to replace the belt?
Any info will be greatly appreciated. 

Riwaka

Page 56 in the guide for 2100sp has a bit about belt tensioning. Looks like alignment is important, might require a dial gauge etc to have the shaft alignment checked.
http://stephensonequipment.com/wp-content/uploads/2016/10/2000-2100.pdf

Thank You Sponsors!