Talon 38cc chainsaw- pooling bar oil. Adjustment screw or bigger issue?

[famreeks]

Talon 38cc- pooling bar oil. Adjustment screw or bigger issue?
I have trying to get this chainsaw starting and running properly. I seem to have that sorted .
 
However , I took the bar off in order to safely run the saw and make idle and L / H adjustments. Whilst I have been running and  adjusting the carbs,  It is then that I noticed at least 10 +mls of oil pooling under the unit. It clean oil and Im sure coming from the bar.
 
Is this normal? Is there an adjustment screw for this?

[lxskllr]

Dunno about the screw. Consumer saws tend to not have adjustment, and I'm not familiar with that saw. If you're running the saw though, it should pump oil whether a bar is on or not. Some saws will also leak a bit after shutoff.

[donbj]

With no bar on it the oil has nowhere to go but pool under the saw