iDRY Vacuum Kilns

Sponsors:

moulder help

Started by dogone, May 12, 2020, 01:16:05 AM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

dogone

    I have Norwood mill and moulder . After a few months I pretty well have sawing basics down  . But the moulder is giving  me fits. I cannot keep the tounge or groove centered on the cant. I am eternally shimming the log to center and even then running off as I go down the log. I am cutting and molding fairly green poplar for a cabin. I am a quarter done and not getting better.
   Should I have left the cants to dry for a while or has anyone any other advise. I assume this molder is similar to the wm . There is almost nothing on any of the forums.

farmfromkansas

Not familiar with your molder, just giving your post a bump.
Most everything I enjoy doing turns out to be work

Thank You Sponsors!