Author Topic: Oregon Versa Cut bar (Read 488 times)

JimStC · « **on:** January 09, 2023, 03:43:48 PM »

Hello to everyone. New member.

I just put a new Versa Cut bar on my 261 and noticed that it has two plastic connected screw heads toward the end of the bar. I cannot fathom a purpose so I am asking the collective wisdom of this forum for an education.

Thank you,
Jim

lxskllr · « **Reply #1 on:** January 09, 2023, 05:32:10 PM »

A picture would help. I looked the Versacut up online, and don't see anything that matches that description.

outinthewood · « **Reply #2 on:** January 09, 2023, 06:01:52 PM »

It sounds like the remains of the "hanger" that the bar would have been hung by. The bars come with a card with details of the bar and are attached by the "screws" you describe and although the card can be torn away easily the screws are pretty tough ! Just unscrew them.

JimStC · « **Reply #3 on:** January 10, 2023, 08:11:42 AM »

Thank you.

ehp · « **Reply #4 on:** January 11, 2023, 06:54:33 AM »

its to hold the hanger part to the bar , I like these bars as they seem to last a long time cutting in sand

Forestry Forum
Sponsored by: