iDRY Vacuum Kilns


Hard nose bar for MS 250

Started by Jim Chance, December 14, 2023, 09:11:21 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Jim Chance

I am trying to make a "root saw". Thisis for use when benching trails. I have an old MS 250 with three carbide chains, but I cannot find a hard nose bar for it. It has the smaller size Stihl mount, the one that the part number begins with 3005. I think this is quality to an Oregon A074 mount.  Does anybody know where I can get a hard nose bar, preferably 16".


I see at least one on ebay. As an alternative, you could run a sprocket nose til it breaks, then have a piece of metal spot welded into the tip, and use it as a hard nose. It's not something I've done, but it would be cheap to try.

Thank You Sponsors!