The Forestry Forum

I see the price of iDry kilns is going up at the end of the month.  I've been reading about them and considering getting one but not sure if I can make the decision soon enought to get the old price.

One thing that I've been thinking about is where I could put it.  The fully heated shop space I have is really too tight.  I have unheated building space but it needs to be in at least moderatly heated space. 

Got to thinking....would the small iDry fit in a 20' shipping container with enough room to operate it?  I don't see any outside dimensions it the specs.  A container could be found that has doors on both ends, or even one that that has end doors and a side that opens up.

Not sure if it would fit in a shipping container. 

One thing to think about if you're putting it in a shop is the heat it gives off (which I did not originally think about). In the winter, this thing will heat a 40 x 60 shop but in the summer it gets real warm in there. I will eventually build it's own building.

Hey everyone...I'm not as active here as I probably should be. I just wanted to say thank you for all the support. 

Happy Drying, 

Jim