The Forestry Forum is sponsored in part by:

iDRY Vacuum Kilns

Forestry Forum
Sponsored by:

TimberKing Sawmills

Toll Free 1-800-582-0470

LogRite Tools

Norwood Industries Inc.

Your source for Portable Sawmills, Edgers, Resaws, Sharpeners, Setters, Bandsaw Blades and Sawmill Parts

EZ Boardwalk Sawmills. More Saw For Less Money! sponsored by Northeast STIHL

Woodland Sawmills

Peterson Swingmills

 KASCO SharpTech WoodMaxx Blades


Sawmill Exchange

Michigan Firewood, your BRUTE FORCE Authorized Dealer

Baker Products


iDRY Wood Lumber Vacuum Drying for everyon

Nyle Kiln Dry Systems

Chainsawr, The Worlds Largest Inventory of Chainsaw Parts

Smith Sawmill Service

Author Topic: Bandit sp2100 engine belt  (Read 553 times)

0 Members and 1 Guest are viewing this topic.

Offline 17inch

  • member
  • *
  • Posts: 5
  • I'm new!
    • Share Post
Bandit sp2100 engine belt
« on: June 25, 2018, 01:24:23 PM »
The engine belt snapped. On one end is a pulley and the other end has a hydraulic drive. Looks like I have to remove both to replace the belt?
Any info will be greatly appreciated. 

Offline Riwaka

  • Senior Member
  • ****
  • Posts: 687
  • I'm new!
    • Share Post
Re: Bandit sp2100 engine belt
« Reply #1 on: June 25, 2018, 04:03:59 PM »
Page 56 in the guide for 2100sp has a bit about belt tensioning. Looks like alignment is important, might require a dial gauge etc to have the shaft alignment checked.

Share via delicious Share via digg Share via facebook Share via linkedin Share via pinterest Share via reddit Share via stumble Share via tumblr Share via twitter

Sliding engine belt tightening.

Started by Kwill on Sawmills and Milling

29 Replies
Last post February 26, 2018, 07:40:07 PM
by pinefeller
Engine Pivoting for Belt Tensioning?

Started by SineWave on Sawmills and Milling

27 Replies
Last post April 10, 2017, 07:10:39 PM
by SineWave
old lt 40 onan engine drive belt question

Started by Polly on Sawmills and Milling

7 Replies
Last post March 16, 2008, 11:00:35 PM
by MartyParsons
Belt drive from engine to blade pulley

Started by Grower on Sawmills and Milling

4 Replies
Last post January 08, 2010, 05:50:27 PM
by eamassey

Powered by EzPortal