iDRY Vacuum Kilns

Sponsors:

WoodMizer LT15 Help

Started by Mark M, May 20, 2003, 04:20:43 AM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages 1 2 All
User actions

Fla._Deadheader

#25
May 22, 2003, 07:03:11 PM
Nobody said anything about winnin a contest?? Ya dint stipulate a perfessiunal performance??  :D
All truth passes through three stages:
   First, it is ridiculed;
   Second, it is violently opposed; and
   Third, it is accepted as self-evident.

-- Arthur Schopenhauer (1788-1860)

Mark M

#26
May 23, 2003, 10:58:57 PM
What is dat Kevin, some kind of slot machine? :D

Kevin

#27
May 26, 2003, 05:56:31 PM
Mark,
You need a steel shaft for the crank assembly and two pulleys at the bottom on the carriage.
You crank the handle one way and it picks up the rope and pulls the head along the bed.
To bring the head back I disengage the crank by pulling back on it and the spool turns free and is independent from the handle.

Mark M

#28
May 27, 2003, 07:56:02 AM
Yep - I have all the parts, what I can't figure out is there must be a bushing missing or something because the crank should have the same ID as the pully bearings since in rides on the same shaft but it is a lot larger.

Mark

jimbo

#29
May 27, 2003, 03:56:37 PM
Mark if your just using for travel  dont warre about it . use the barings on a 5/8 bolt whear you can keep the handle engage  in the pully  that all it takes for that    Good luck






             jimbo

Kevin

#30
May 27, 2003, 06:19:50 PM
It's a nice feature having it disengage so it isn't spinning around when you pull the carriage back.
Print
Go Up Pages 1 2 All
User actions

Thank You Sponsors!