The Forestry Forum
General Forestry => Drying and Processing => Topic started by: Raym on May 28, 2017, 07:09:13 AM
Looking for some holiday weekend help for L200m.
Ordered a new board for unit, the old one worked except moisture probes would not read and nyle said it was due to lightning).
Recieved new board but had to wait to receive new backplate. Recieved new backplate and have all wires connected properly.
When I turn on controller, (version 2.5) the display is different from old board and the only setting I can adjust is the wet and dry bulb settings. Moisture probes don't show up, can't enter wood group, can't enter final moisture. And none of the relays come on....heat, compressor, vent etc.....
Any help would be appreciated.