Pages: [1] 2 ... 40
Trying to locate a good used mandrel with bearings carriers, good collars and a 24-26 in c belt drive pulley. It would be replacing an old farquar that was on the mill, the old one was 5ft long 2'3/16

0 Comments
I installed the Woodmizer Power Feed on my LT15 3 weeks ago. My first comment is "why did I wait so long!". It is great and saves so much hard work, especially easy on my back.

A few details, this is an electric mill that is stationary.

Now for the problem. It worked great last week but today I ran into problems. First, even though I took the rope off the end when not in use, it was too loose and needed tightened (a new knot). Now when I put the head in reverse, the mill shuts off. It works fine moving forward but not in reverse. My solution while sawing a very large red oak was to move the head back manually.Read More

1 Comment
At 84 probably last logging job.

7 Comments
I have my gearmatic 119 out of the TJ 240E and Im thinking about changing all the bearings while i am working on the clutch and brake.
I need to get the end play and backlash specs for the ring and pinion so if i have to shim the pinion i will set it up right. does anyone have these specs?
I also have beel looking for a bearing and seal kit for this winch. does anyone have a source where i can get a kit or do i have to get the bearings and seals individually( is it cheaper to do it that way. Read More

1 Comment
The village guy dropped off 3 50in pcs of cottonwood about 14" dia

So I made stickers Does anybody like making these?
I cut them 1" x 1"
I'll see what they dry to.
Read More

19 Comments
Pages: [1] 2 ... 40