Hi all, I am looking to add a CTL to the fleet for a variety of reasons. My tractor is great for many things, but I am pushing its limits of lifting near daily.
I have narrowed down my want list to either a Kubota SVL75 or SVL97. The 97 would be grand, but dealing with DEF and further emissions is a drawback, as well as the cost difference.Read More
I have narrowed down my want list to either a Kubota SVL75 or SVL97. The 97 would be grand, but dealing with DEF and further emissions is a drawback, as well as the cost difference.
So a local business has reached out to me with a request to provide an ongoing supply of 2x4's for their shipping needs.
These will be a one time use, southern yellow pine, and the numbers are very good. They go through them so quickly that they don't need to be dried or even stickered. Initial estimate
A 18" diameter top on a Shaker candle stand I completed last week.
I had to tell the truth. My board was at best 1c or a lower grade. I'm far to cheap to use those wide boards in my projects.
I did take the question as a complement and went on to explain grain matching. I get irritated when I see these...
This came up on the Earth Uncovered channel. this is the channel that has the water wheel shaft turning video
...
I'll start this thread with my most recent adventure. My 70Super is a 2019 Wide model. 55 hp tier 4 Yanmar. Please keep in mind that 70 Super has engine driven hydraulics, Power feed and up down are via hydraulic cylinders.
So I just finished installing a new 2 inch cylinder that raises and lowers the