CRD saw motor ?

[SPD748]

Hello all,

I'm in the design stage of a small (very small) processor that I'd like to build around CRD's (large) saw motor. I'll call them tomorrow to get specifics however (I'm so impatient) would anyone here happen to know what gpm/psi this motor requires? I've got the deck, trough, clamp and ram worked out which leaves the saw as the last hydraulic variable. Thanks guys!

-lee

[Holmes]

I can't help you and I can't wait to see the pictures   ;D 8)

[blackfoot griz]

Hello all,

I'm in the design stage of a small (very small) processor that I'd like to build around CRD's (large) saw motor. I'll call them tomorrow to get specifics however (I'm so impatient) would anyone here happen to know what gpm/psi this motor requires? I've got the deck, trough, clamp and ram worked out which leaves the saw as the last hydraulic variable. Thanks guys!

-lee
[/quote]



 
The saw motor is a Danfoss .77 cu inch. w a 3/4 inch shaft. The 13 tooth sprocket is held on the shaft with a Martin JA 3/4 QD bushing. Mount is a SAE 2 bolt-type A.